Asbestos Safety

Asbestos

General

Asbestos is a naturally occurring mineral fiber. It was used in numerous building materials and vehicle products for its strength and ability to resist heat and corrosion before its dangerous health effects were discovered. Individual asbestos fibers cannot be seen by the naked eye, which puts workers at an increased risk. The Occupational Safety and Health Administration (OSHA) has regulations to protect workers from the hazards of asbestos. 

What is the Hazard? 

Asbestos fibers are released into the air during activities that disturb asbestos-containing materials. The asbestos fibers can then be inhaled without knowing and trapped in the lungs. If swallowed, they can become embedded into the digestive tract as well. 

Asbestos is a known human carcinogen and can cause chronic lung disease as well as lung and other cancers. Symptoms and/or cancer may take many years to develop following exposure. 

Where is the Hazard? 

The hazard may occur during manufacturing of asbestos-containing products; performing brake or clutch repairs; renovating or demolishing buildings or ships; or cleanup from those activities; contact with deteriorating asbestos-containing materials and during cleanup after natural disasters. 

Some materials are presumed to contain asbestos if installed before 1981. Examples of these materials, as well as other presumed asbestos-containing materials are: 

  • Thermal system insulation
  • Roofing and siding shingles
  • Vinyl Floor tiles
  • Plaster, cement, putties, and caulk
  • Ceiling tiles and spray-on coatings
  • Industrial pipe wrapping
  • Heat-resistant textiles
  • Automobiles brake linings and clutch pads

What Protections Exist in the Standards? 

   Permissible Exposure Limit (PEL) for asbestos is 0.1 fiber per cubic centimeter of air as an eight- hour time-weighted average (TWA), with an excursion limit (EL) of 1.0 asbestos fibers per cubic centimeter over a 30-miute period. The employer must ensure that no one is exposed above these limits. 


   Assessment of workplaces covered by the standards must be completed to determine if asbestos is present and if the work will generate airborne fibers by a specific method under each standard. 


   Monitoring necessary to detect if asbestos exposure is at or above the PEL or EL for workers who are, or may be expected to be exposed to asbestos. Frequency depends on the work classification and exposure. The construction standard requires assessment and monitoring by a competent 
person. 


   If the exposure has the potential to be above the PEL or EL, employers must use proper engineering controls and work practices to the extent feasible to keep it at or below the PEL and EL. Where feasible engineering controls and work practices do not ensure worker protection at the exposure limits, employers must reduce the exposures to the lowest level achievable and then supplement with proper respiratory protection to meet the PEL. The construction standard contains specific control methods depending on work classification, and the general industry standard has specific controls for brake and clutch repair work. 


   Proper hazard communication and demarcation with warning signs containing specified language in areas that have exposures above the PEL or EL is necessary. No smoking, eating, or drinking should occur in these areas and proper PPE must be provided and used to prevent exposure. 


   Separate decontamination and lunch areas with proper hygiene practices must be provided to workers exposed above the PEL to avoid contamination. 


   Training requirements depend on the workplace exposure and classification. Training must be provided to all workers exposed at or above the PEL before work begins and yearly thereafter. All training must be conducted in a manner and language in which the worker is able to understand. Workers who perform housekeeping operations in buildings with presumed asbestos-containing materials but not at the PEL must also be provided asbestos awareness training. 


   Medical surveillance requirements are different depending on the industry. Medical surveillance must be provided for workers who engage in certain classifications of work or experience exposures at or above the PEL in construction and shipyards. In general industry, medical examinations must be provided for workers who experience exposure at or above the PEL. 


 

   Records must be kept on exposure monitoring for asbestos for at least 30 years, and worker medical surveillance records retained for the duration of employment pus 30 years. Training records must be kept for at least one year beyond the date of last employment. 
Additional Information 
OSHA has three standards to protect workers from the hazards of asbestos depending on the type of workplace; General Industry, Construction, & Maritime. Please see applicable standards as well as the J.J. White, Inc. Asbestos & Asbestos Management policies for more information.